July 19, 2023
1. The connection between the insulation board and the leveling layer of the base wall adopts the method of full adhesion and anchorage. 2. When the thermal insulation board is used as the thermal insulation layer and the decorative layer is paint, anchors may not be provided if the floor height is 24 meters or less, and anchors shall be provided if the floor height is 24 meters or more to 60 meters. ) to set up one anchor piece, and set up one anchor piece at a distance of not more than 600mm in the horizontal direction. From more than 60 meters to 100 meters, one anchor is set for each layer (height is not more than 4.5 meters) in the vertical direction, and one anchor is set at a distance of not more than 600mm in the horizontal direction. Special plates for anchors should be used where anchors are installed, and should be installed on concrete components such as beams, slabs, and walls. An anchor should be provided at the long limb when a special board for yin and yang corners is used. 3. When the coating is used for the walls within 2.4 meters above the outdoor ground of the building and the walls with special requirements for impact resistance, a layer of alkali-resistant coated mesh should be added for reinforcement. 4. When facing the brick surface, install one anchor piece for each layer (height not greater than 4.5 meters) in the vertical direction, and set one anchor piece at a distance of no more than 600mm in the horizontal direction. 5. The facing material should be compatible with the constituent materials of the stp insulation board system. The above is the information about polyurethane board for you, and I hope it will help you. If you have any questions or needs, please contact us, and we will provide you with stable, reliable and energy-saving products.
